Why Does My Sourdough Have Holes Only at the Top and a Solid Bottom?
Why Does My Sourdough Have Holes Only at the Top and a Solid Bottom?

What this crumb means
When your sourdough has holes only at the top and a solid, unopened slab underneath, the loaf is telling you fermentation ran out of steam halfway through. Gas rose and gathered in the upper part of the dough, while the bottom half never got properly aerated. The two halves of the same loaf baked like two different breads — light and open up top, heavy and tight down below.
Our 15 Common Sourdough Problems & Fixes guide walks through this pattern and the proofing checks behind it — here is the short version.
Why it happened
- Underproofing is the most likely cause. The dough went into the oven before fermentation had worked its way evenly through the whole loaf, so only the top — where gas naturally collects — opened up.
- A sluggish starter. A starter used before its peak (or after it collapsed) ferments unevenly and slowly, and the bottom of the loaf pays for it.
- Cold dough, cold bake. Dough that proofed in a cold spot, or a vessel that was not fully preheated, sets the bottom crust early and traps that half dense.
- Shaping that seals the top. A very tight surface with gas pushed upward can exaggerate the split between the two halves.
The fix for your next bake
- Proof longer, and judge by feel. Let the shaped loaf proof until it feels light and puffy and a floured fingertip leaves a slow, partial spring-back — not a quick bounce.
- Use your starter at its peak — risen, domed, and full of bubbles — so fermentation runs steadily through the whole dough.
- Proof in a warm, even spot away from cold counters and drafts, so the bottom of the loaf ferments at the same pace as the top.
- Preheat your pot or stone fully so the base gets heat from the first minute instead of slowly warming through.
Is this the same as a dense bottom layer?
Close cousins, different story. A thin dense layer at the very base is usually a heat or shaping issue. When the whole bottom half is solid and only the top opens, that is fermentation that stopped short — proofing is the lever to pull first.
Get Your Starter — Guaranteed to Activate, Beginner-Friendly →
Work through the full list of crumb problems and fixes →
Get a Reliable Starter, Shipped Free in Canada, the US & the UK →
Questions? Just message us — we'll get back to you, we promise. No AI chatbots here, just real people who bake sourdough every day.
Our 100% Activation Guarantee
Zero Risk. Zero Guesswork. Just Real Sourdough.
Bake or Get Covered: If your starter fails to activate into a bubbly, active, bake-ready culture.
We’ll either send you a fresh replacement batch completely free or issue a 100% refund.
No hoops to jump through, no complicated returns, and no hard feelings.